NANO MISTER USB nano-vaporizer white 40ml

1. Connect the charging cableat the bottom of the device and connect the other side with a USB input. After about2 hourscharging will be complete.
2. Unscrew the cap and add waterto the tank, then close it again.
3. Slide the switch downto open the spray mouth. The blue LED light indicates that the device is working, the red light indicates the charging phase while the green light indicates that the charging is complete. By pressing the switch that starts the LCD screen you can always monitor the battery status.
4. If used for eyelash extension treatment:It is recommended to use distilled water. At the end of the extension treatment, position the device about 20cm from the client's face and create a cloud of humidity around the eyes, leaving the vaporizer active for about 4/5 seconds. It is important to note that you should not create water droplets on the face and/or eyelashes, as they would produce the opposite effect, i.e. shock polymerization, which would decrease the hold of the eyelash extensions.If used on the face:It is recommended to use mineral water. Press the start switch to activate the LCD screen. Through the metal probe, you can check the skin condition data on the screen at any time. Hold the device about 5cm from your face if you are without makeup and about 12cm if you are wearing makeup.
   

NOTE: During use, a small amount of water droplets may be deposited around the spray mouth. After use, wipe them off with a paper towel. To clean the device, use a soft damp cloth (without any detergent) and then dry.